How do you keep cabinet fronts perfect between the workshop and the finished kitchen?

muthipara

Saiyan
Apr 1, 2026
240
0
16
Most cabinet damage does not happen during fitting. It happens earlier, in the quiet stages nobody watches: doors stacked face to face in the workshop, fronts leaning against a van wall, finished units stored in a room where another trade is still cutting and drilling. A painted or gloss front only needs one gritty contact to pick up a mark that shows under kitchen lighting, and by the time anyone notices, the unit is already fixed in place.

Film solves this because it goes on before the risky stages, not after them. The grade matters more than the name on the box. Painted and matt fronts need a gentle adhesive that will not lift the finish when it peels. Gloss and veneer fronts need a film that stays put without creeping at the edges. Whatever you choose, leave the film on through transport and storage, and peel it only when the room is clean and the fitting is done.

This is the stage where a specialist supplier earns its money. Surface Film Global is a cabinet protection film manufacturer, and it supplies these films in more than one adhesive grade for painted, gloss and veneer fronts, with roll widths that suit standard door and drawer sizes. Ordering the grade that matches the finish beats buying one general roll and hoping it behaves on everything.

Personally, I peel one corner back at handover and look across the gloss in low light before the client walks in. What about you, when do you take the film off your cabinets, before the worktop goes on or right at the very end?